Metal roofing
Architectural shingles
Tile roofing
GAF
Owens Corning
Flat & low-slopeFree roof inspection with deck photos before we talk money - GAF and Owens Corning certified installation
Tamko Roofing Company in Jacksonville: What to Know First
We’re an independent Tamko roofing company serving Jacksonville, and we repair and replace Tamko shingle roofs using OEM or spec-matched materials with most jobs completed in one to two days once we’re on site. You’ll never guess at pricing: most Tamko roof repairs in Jacksonville run $425 to $1,850 depending on scope, and a full Tamko replacement on an average Jacksonville single-story typically lands between $8,500 and $14,000. You’ll have the price in writing before we touch a shingle. This page is for Jacksonville homeowners with Tamko shingles, especially those with older Heritage or Elite series roofs showing their age. If you suspect wind lift, granule loss, or flashing failure, call (904) 604-7914 and we’ll walk the roof with you.
We’re Birchbark Roofing Jacksonville, led by Erik Lindgren, and we’ve spent years working on Tamko roofs from Riverside to San Marco to the beaches. As an independent Tamko service provider, we’re not tied to any manufacturer’s playbook, so the fix we recommend is the one your roof actually needs.
How Tamko Products Fail – and How We Fix Them
Tamko shingles are solid roofing, but Jacksonville’s heat, humidity, and summer downpours expose weak points over time. Here’s what we see and what we do:
- Heritage series granule shedding on west-facing slopes. Tamko Heritage shingles, especially roofs installed 12 to 18 years ago, lose granules faster on slopes that take full afternoon sun. You’ll notice bare patches and sandy grit in the gutters. The fix is usually targeted replacement of the worst sections before the mat becomes exposed. We match color and exposure so the repaired area blends.
- Elite series raised-nail wind lift after tropical storms. Tamko Elite uses a heavier shingle, but if the original installer set nails too high on the nail strip, strong Jacksonville winds will peel corners. The shingle cracks at the bend point. We reseal lifted tabs where the sealant still has life and replace the cracked ones individually, rather than condemning the whole slope.
- Titan XT nail-strip tear-out on steep pitches. Titan XT, Tamko’s thicker architectural line, is a good shingle, but on steep roofs like you see in some older San Marco and Ortega homes, high nailing creates a pivot point. The shingle eventually tears at the fastener under repeated thermal cycling. We correct the fastening pattern on replacement rows and reseat neighboring tabs.
- Valley ice-and-water failures on hip and valley roofs. Not a shingle problem per se, but a Tamko roof in Jacksonville will fail first where two planes meet. Without proper valley flashing under the Tamko shingles, water follows the seam and rots the decking underneath. We open the valley, replace the underlayment, and re-lay the Tamko shingles to manufacturer exposure, not just “close enough.”
- Flashing separation at chimneys on older Tamko roofs. Jacksonville’s daily expansion and contraction in the summer eventually breaks the seal between step flashing and the chimney brick. Water runs behind the Tamko shingles and stains ceilings below. We strip the affected area, install new step and counter flashing, and re-shingle. This is one of the most common Tamko repairs we handle.
Styles & brands we work with






Our Tamko Roofing Company Process
- 1
Inspection and documentation. Erik or one of our background-checked, uniformed technicians walks the entire roof, photographs every problem area, and talks through findings with you at ground level before anything is removed.
- 2
Written price. You get a line-item price in dollars covering materials, labor, and disposal. Not an estimate range. The number we write is the number you pay unless we both agree in writing to a change.
- 3
Parts and materials decision. For Tamko repairs we source OEM Tamko shingles where color and production lot matter, and use manufacturer-spec underlayment, flashing, and fasteners throughout. Warranty-safe practices only.
- 4
Protection before the work starts. Shoe covers at the door, drop cloths through the hallway and around the perimeter, and a door schedule if you have pets or kids at home. We use pet-safe products where there’s a choice.
- 5
The repair or replacement. We work section by section, keeping the area covered if rain is in the forecast, and sweep magnetic nails before we open the gate.
- 6
Final walkthrough and clean-up photo. You see the finished roof up close, and we show you a photo of the cleared job site before we leave. Every job carries the 365-Day Done Right Promise: if it’s not right, we make it right.
See the difference
Before
After
Before
After
Before
AfterWhat Tamko Roofing Company Costs in Jacksonville
Here are the ranges we quote most often for Tamko work in Jacksonville:
- Individual shingle replacement: $425 to $750
- Flashing repair at a chimney or wall: $650 to $1,200
- Leak investigation with minor repair: $400 to $850
- Partial slope re-shingle (Tamko Heritage or Elite): $1,800 to $4,500
- Full Tamko roof replacement (single-story, 1,400 to 1,800 sq ft): $8,500 to $14,000
The big price drivers are roof pitch, the number of stories, decking condition, and whether we’re matching existing Tamko color lots. Steep roofs and second stories add setup time. Rotted decking shows up once we open a bad section and gets addressed before we re-shingle. Call (904) 604-7914 to schedule a free estimate. You’ll have a written number before you commit to anything.
Why Jacksonville Homeowners Call Birchbark Roofing Jacksonville for Tamko Work
Because a Tamko roof deserves a roofer who knows its habits. We’ve worked on enough Heritage, Elite, and Titan XT roofs in Jacksonville to know where they fail and what a real fix looks like, not a patch that buys one rainy season. If your Tamko roof calls for something we’re less confident in, we also work regularly with GAF, Owens Corning, and CertainTeed products, so our recommendation is based on your roof’s needs, not what’s left in inventory. We’re part of the Cedarwell family of roofing companies, and every job carries the Cedarwell Care Promise: Clean up like it is our own home, Ask before we move or touch anything, Respect the family’s time and quiet hours, Explain the price before the work. Erik and the crew have been serving Jacksonville homeowners for years, and the 365-Day Done Right Promise is stamped on every repair and replacement we perform. You’ll have the price in writing before we touch a shingle.
FAQs
No. Tamko’s warranty covers manufacturing defects, and properly performed repairs using Tamko shingles or specification-matched materials won’t void it. We install to Tamko’s published exposure and fastening requirements so your warranty stays intact.
If the damage is isolated, we can usually complete the repair in one visit. Larger flashings or partial slopes may run a second day. Call (904) 604-7914 and we’ll tell you honestly what your roof needs and when.
It depends on the age of the shingles, the number of failures, and the decking condition. If the roof is under 12 years old and the issue is isolated, a repair usually makes sense. If you’re chasing multiple leaks or the shingles are worn to the mat across several slopes, replacement estimates become worth comparing. We’ll show you what we see and let you decide.
We’re an independent Jacksonville roofing company and work with Tamko, GAF, Owens Corning, CertainTeed, and other major brands. On Tamko jobs we’ll source Tamko materials where color and spec matter.
Not without your written approval. The price we hand you covers the agreed scope. If we find hidden decking damage, we’ll stop, show you what we found, and put a new number in writing before any additional work proceeds. Estimates are free. Call (904) 604-7914.
Written by Erik Lindgren, Owner, Birchbark Roofing Jacksonville at Birchbark Roofing Jacksonville, serving Jacksonville and nearby areas.